Versions Compared

    Key

    • This line was added.
    • This line was removed.
    • Formatting was changed.
    Comment: Published by Scroll Versions from this space and version 6.9-0

    Configuration

    There are 3 settings in the supervisor's qb.conf that need to be set in order to enable your supervisor to send mail:

    • mail_domain = <your mail domain name>
    • mail_host = <your SMTP mail hostname or IP address>
    • mail_administrator = <address or mailing list to receive supervisor-related emails; warnings, license notifications, etc.>

    If your email server requires SMTP AUTH, which most modern systems do, you will need to further set up the following 3 parameters:

    Tip

    New in Qube 6.9

    Optionally, you may specify the mail_port if the SMTP server listed in mail_host is listening on a port other than one of the default ports (25 for DEFAULT, 465 for SSL, and 587 for TLS). Leaving mail_port commented out or setting it to 0 will use the default.

    The SMTP host may need to be configured to accept and forward mail from your supervisor host machine.  You will need to refer to the documentation for your particular SMTP mail host's application.

    Note

    You will need to restart the supervisor service in order to apply your changes. See: How to restart the Supervisor

    Testing

    You may use the qbadmin command from any workstation to test your supervisor's mail capabilities.  The output is the result of the conversation between your supervisor and the SMTP host.

    ==================================================================================

    jburk$ qbadmin s --emailtest
    START

    RECV(l=70)
    data=[220 omta16.emeryville.ca.mail.comcast.net comcast ESMTP server ready
    ]

    SENT
    HELO jburk-17-mbPro.local

    RECV(l=84)
    data=[250 omta16.emeryville.ca.mail.comcast.net hello [24.20.42.74], pleased to meet you
    ]

    SENT
    MAIL FROM:<qube@pipelinefx.com>


    RECV(l=43)
    data=[250 2.1.0 <qube@pipelinefx.com> sender ok
    ]

    SENT
    RCPT TO:<jburk@pipelinefx.com>


    RECV(l=47)
    data=[250 2.1.5 <jburk@pipelinefx.com> recipient ok
    ]

    SENT
    DATA


    RECV(l=50)
    data=[354 enter mail, end with "." on a line by itself
    ]

    SENT
    From: "Qube! - Supervisor" <qube>
    Organization: PipelineFX
    To: jburk@pipelinefx.com
    Subject: qbadmin - test email
    Content-Type: text/plain; charset=us-ascii
    Content-Transfer-Encoding: 7bit

    This is a simple test mail send from qbadmin.
    .


    RECV(l=67)
    data=[250 2.0.0 Xa9o1k00A1c0X0g8ca9oay mail accepted for delivery
    To: jb]

    SUCCESS

     

    SUCCESS: sent mail to user: jburk@pipelinefx.com via: smtp.comcast.net

    ==================================================================================

    If everything goes well, you should receive an email containing "This is a simple test mail send from qbadmin." in the message body.

    If you don't see the SUCCESS lines, chances are your SMTP server is either incorrectly specified, not reachable, or refusing the connection.